Overview
The Massey Ferguson 1100 and 1130 Tractor Workshop Service Manual provides technical reference information for maintaining, inspecting and repairing these Massey Ferguson agricultural tractors. The documentation covers the Perkins A6.354 engine fitted to the MF 1100 and the AT6.354 engine fitted to the MF 1130, with sections addressing engine overhaul, tightening torques, cylinder liners, pistons, crankshaft assemblies, valve components and electrical equipment.
The technical information includes engine dimensions, compression ratio, firing order, valve tappet settings, operating speeds, horsepower ratings and engine torque specifications. Workshop references also identify tightening torque values for cylinder heads, connecting rods, main bearings, flywheels, rocker shaft brackets and crankshaft pulleys, providing important specifications for engine inspection and overhaul work.
Table of Contents
Massey Ferguson 1100, 1130 Manual
-
01. General Information
- Engine Applications – MF 1100 and MF 1130
- Perkins A6.354 and AT6.354 Engine Specifications
- Engine Bore, Stroke and Cylinder Arrangement
- Total Piston Displacement
- Engine Compression Ratio
- Cylinder Firing Order
- Engine Valve Tappet Settings
- Engine Low Idle Speed
- Rated Engine Speed
- Maximum No-Load Engine Speed
- Engine Weight Specifications
- Engine Horsepower Ratings
- Power Take-Off Horsepower References
- Engine Torque Specifications
-
02. Engine Overhaul
- Engine Overhaul Specifications
- Perkins A6.354 Engine References
- Perkins AT6.354 Engine References
-
03. Torque Tensions and Engine Fastener Specifications
- Cylinder Head Tightening Torques
- Connecting Rod Tightening Torques
- Main Bearing Tightening Torques
- Flywheel Tightening Torques
- Rocker Shaft Bracket Tightening Torques
- Crankshaft Pulley Tightening Torque
- 04. Cylinder Liners
- 05. Pistons
- 06. Crankshaft
- 07. Valves
- 08. Electrical System
Perkins Engine Identification and Overhaul Specifications
The Massey Ferguson MF 1100 is identified with the Perkins A6.354 engine, while the MF 1130 uses the AT6.354 engine. Both engines have six cylinders, a nominal bore of 3-7/8 inches, a 5-inch stroke and a total displacement of 354 cubic inches. The listed compression ratio is 16:1, with a firing order of 1-5-3-6-2-4. Valve tappet clearance is specified as 0.010 inch hot or 0.012 inch cold, and rated engine speed is 2,200 rpm.
The supplied overhaul specifications list cylinder head tightening torque at 80–85 ft-lb, connecting rod torque at 65–70 ft-lb, main bearing torque at 145–150 ft-lb, flywheel torque at 74–80 ft-lb, rocker shaft bracket torque at 50–55 ft-lb for 7/16-inch capscrews, and crankshaft pulley torque at 275 ft-lb. These figures are taken from the supplied reference page; consult the applicable workshop instructions for the complete tightening procedure and engine-specific service requirements.
Reviews
There are no reviews yet.